Hydraulic cylinders ISO 6020/2 with tie-rods

Tie rods hydraulic cylinder, in compliance with ISO 6020/2 standard, also for use with magnetic sensor.
Available for all the mountings defined on the standard, in several sealing configuration.
All the cylinder are tested in compliance with ISO 10100 standard.

Standard ISO 6020/2 - DIN 24554
BORES CD: 25 - 32 - 40 - 50 - 63 - 80 - 100 mm
DK: 125 - 160 - 200 mm
MD: from 25 to 125 mm
OPERATING PRESSURE Operating: 160 bar
Test: 240 bar
THREADED HOLES Front ISO MX5
Rear ISO MX6
FLANGE Front ISO ME5
Rear ISO ME6
FEET Front and rear ISO MS2
CLEVIS Ball jointed eye ISO MP5
Male clevis ISO MP3
Female clevis ISO MP1
TRUNNIONS Front ISO MT1
Intermediate ISO MT4
Rear ISO MT2
EXTENDED TIE-RODS Front and rear ISO MX1
Front ISO MX3
Rear ISO MX2
HIGH SEALING Max. speed: 0.5 m/s
Temperature: -20 / +80 °C
Fluid: hydraulic oil
LOW FRICTION Max. speed: 1 m/s
Temperature: -20 / +80 °C
Fluid: hydraulic oil
VITON Max. speed: 1 m/s
Temperature: -20 / +150 °C
Fluid: hydraulic oil / Phosphoric esters
HFC-FLUID Max. speed: 1 m/s
Temperature: -20 / +80 °C
Fluid: HFC-fluid
Rod material Chrome-plated CK45 steel
Hard chrome-plated stainless steel
Hardened and tempered chrome-plated steel
Nikrom steel
Hardened chrome-plated steel
Rod end Male thread
Female thread
Floating joint
Proximity switches Front and/or rear with protection
Magnetic switches Reed
PNP magnetostrictive
IO-LINK special sensors
CETOP PLATE ISO 4401-03 NG6
ISO 4401-05 NG10
Bushing drain On demande